LOGO3.jpg
title logo.jpg

B&W Engineering Corp.

3303 Harbor Blvd.

Costa Mesa, CA 92626

714.540.9975

714.540.2662 FAX

9.jpg
dsc.jpg

DSC-1 Digital Sine Vibration Controller Specifications

 

FREQUENCY

  • RANGE: 2 to 6250 Hz, digitally synthesized
  • STABILITY:  +/- 100ppm/Co , crystal-controlled
  • DISTORTION:  <0.50% THD, 0.25% typical
  • LIMITS:  Sweeps between programmed upper and lower limits

SWEEP MODES

  • CONTINOUS:  Up to 9999 cycles between set limits
  • DWELL:  Two programmable dwell points and durations
  • HALF-CYCLE:  Up or down for responcs plotting
  • MANUAL:  With keyboard or icon arrows
  • SWEEP:  Logarithmic, linear, or MIL-167

SIGNAL INPUTS

  • INPUT CHANNELS:  Two channels, one control & one response
  • INPUT SENSITIVITY:  Software settable from 8 to 1000 mV/G
  • CURRENT SOURCES:  4 mAmp each input 18VDC compliance

SIGNAL OUTPUT

  • SERVO OUT:  0-5 VRMS for amplifier drive, short protected

TEST PROFILES

  • CONTROL:  D,V or A - Displacement, Velocity or Acceleration
  • BREAKPOINTS:  Up to 32 breakpoints, automatically calculated D,V & A
  • STORAGE:  Profiles and Test  Reports may be stored to disk for recall

SERVO COMPRESSOR

  • DYNAMIC RANGE: >70 dB
  • CONTROL ACCURACY:  <+/- 0.5 dB nominally
  • COMPRESSION RATE: SLOW - 0.1 dB/Sec/Hz
  • MED - 0.3 dB/Sec/Hz
  • FAST - 1.0 dB/Sec/Hz
  • COMPRESSION SPEED LIMIT:  Programmable from 200 to 1000 dB/Sec
  • CONTROL LIMITS:  From 0.2 to 200 Gs with 10 mV/G input

DISPLAY MONITOR

  • SWEEP:  Frequency, direction, rate, lower limit, upper limit, sweep count
  • COMPRESSOR:  Rate, speed, dB of compression
  • ACCELERATION:  0 to 200 Gs peak
  • VELOCITY:  0 to 200 inches/Sec
  • DISPLACEMENT:  0 to 10 inches peak-peak
  • TIME:  Time, date, test run time
  • UNITS:  English or metric

TEST ARTICLE PROTECTION

  • ABORT LIMIT:  Programmable 1 to 99 dB
  • SYSTEM LIMITS:  Programmable for D, V, A, and Hz
  • CONTROL:  Open loop and low gain detectors
  • MANUAL ABORT:  From keyboard or mouse

TEST DOCUMENTATION

Complete test reports can be stored to disk or printed out in color or black & white on any Windows compatible printer .

SYSTEM REQUIREMENTS

  • COMPUTER:  486DX33 or better with VGA display, 8 mb RAM, and Windows
  • POWER:  <10 watts from computer bus.
  • SIZE:  Standard AT 3/4 size PC card (9.5" x 4.625")

Specifications are subject to change without notice